Clown - Pennywise Iced Out Shortfill E-Liquid (50ml)

Pennywise Iced Out shortfill e-liquid from Clown is recommended for vapers using a DTL (direct to lung) style vape device. 

Pennywise Iced Out from Clown combines the candy blend of Pennywise with a menthol finish. On inhale, a bubblegum flavour is present from your first vape, with sugary notes and a fruity aftertaste. The juicy tasting strawberry and watermelon on exhale is blended with an icy wave of menthol for a smooth finish. This fruit flavoured e-liquid is a 30% PG / 70% VG blend best suited for subohm devices to make the most out of this shortfill.

Manufactured in New York, Clown is a range of premium US e-liquids that takes inspiration from carnival treats. Gory, maniacal, twisted and terrifying flavours with candy and fruity blends. 

Clown e-liquids are big in flavour. Each 60ml sized bottle includes 50ml of e-liquid leaving you 10ml for your desired nicotine shot to create a 3mg shortfill e-liquid.

What's in the box?

• 1 x Pennywise Iced Out 50ml shortfill e-liquid

What devices can I use with this shortfill e-liquid?

Pennywise Iced Out by Clown is a high VG e-liquid. The VG percentage is more than half of the total content, this means that it requires a high powered subohm style device to be vaped optimally. We would advise using an advanced vape device or tank such as the SMOK Rigel Advanced Vape Kit or the Geekvape Zeus Tank for this shortfill e-liquid.

Sub ohm vaping is when the coil you're using is rated at an ohm rating under 1.0 Ohms. Sub Ohm vaping produces more vapour, more clouds and in-turn more flavour from your e-liquid. 

How to mix a shortfill e-liquid:

1. Ensure you are adding your chosen nic shot to a 0mg, non nicotine based e-liquid. Ensure to check the guidelines below to determine how many nic shots you will need to add to reach your desired strength.
2. Remove the cap and nib from your chosen non-nicotine based shortfill. A pair of non slip gloves and/or a small tool lever the nib off will help with this.
3. Remove the cap and tamper seal from the nicotine shot. Slowly squeeze the contents of your bottle into your non-nicotine based shortfill, being careful to ensure no spillages occur. Wash hands and surfaces thoroughly with warm water if any spillages do occur.
4. Once the nicotine shot has been fully decanted into your non-nicotine shortfill, replace the nib, removing any temporary silicone seals that were present, ensuring that it makes a solid seal.
5. Replace cap, and hand shake the bottle thoroughly for five to ten minutes to ensure the full mixture of both your shortfill and nicotine strength.